Local module identification – EXFO FTB-800 Series for FTB-1 User Manual
Page 476
Test Control
466
FTB-700G/800 Series
Discover Remote Button
DTS Connect and DTS Disconnect buttons are only available with
EtherSAM and RFC 2544 test applications.
DTS Connect establishes the connection with the selected remote
module and sets the remote module into either DTS RFC 2544 or
DTS EtherSAM test application, depending on the active test on the
local module.
If a remote module is in any busy status a user confirmation is
required to proceed with the Loop Up command.
Following a successful connection, the IP address of the remote
module will be used as the destination IP address for the test.
DTS Disconnect ends the connection between the local and the
remote modules.
Local Module Identification
Module ID is used to easily identify this module in case another module is
performing a discovery scan. Up to 16 alpha-numeric characters are
allowed.