EXFO FTB-800 Series for FTB-1 - Manual (Page 78)

Selecting and Starting a Test
68 FTB-700G/800 Series
Transport Test Applications
3d. Tap the test block to configure the specific test settings (refer to
page 77). Not available with NI/CSU Emulation test application.
3e. Tap the clock block to configure the clock synchronization (refer
to Clock on page 110).
4. Tap the Timer tab to automatically start and/or stop the test at a given
time or for a specific duration (refer to Timer on page 234).
5. For additional test configurations refer to Test Functions on page 385.
6. Tap the Start button from the right navigation bar to start the test. (refer
to Start/Stop Button on page 492). The Summary result page will be
automatically displayed when the test is started from any Setup
configuration page. For additional results, refer to Test Results on
page 241.
7. Tap the Stop button to stop the test. By default the generate report
pop-up is displayed. If required, tap Yes to generate a report of the test
results and statistics (refer to Report Button on page 481).