Ping – EXFO FTB-800 Series for FTB-1 User Manual
Page 447
Test Functions
NetBlazer
437
Ping & Trace Route
Ping
Data Size (Bytes): Enter the data size that will be sent to the network
device to be detected. Choices are 0 to 1452 bytes; 32 bytes by
default.
TTL for IPv4 and Hop Limit (TTL) for IPv6: Enter the maximum
number of hops the packet can go through. Choices are 1 to 255; 128
by default.
IP TOS/DS for IPv4 and Traffic Class (TOS/DS) for IPv6: Enter the type
of service. Choices are 00 (default) to FF.
Flow Label (IPv6) value acceptable range is from 0 (default) to
1048575.
Timeout (ms): Enter the maximum time allowed between an ICMP
echo and response. Choices are 200 ms to 10000 s; 4000 ms by
default.
Delay (ms): Enter the delay between each attempt (PING). Choices
are 100 to 10000 ms; 1000 ms by default.
Attempts: Select n-Attempts to specify the number of ping requests to
send following a ping activation or select Continuous to ping
continuously until manually stopped. If n-Attempts is selected, enter
the number of ping attempts from 1 to 100. The default setting is
n-Attempts with 4 attempts.
Ping button starts the ping tool with the specified settings.