Cisco 15327 - Manual (Page 245)

15-3
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 15 Configuring the Switching Database Manager
Configuring Access Control List Size in TCAM
Configuring Access Control List Size in TCAM
The default maximum size of the ACL is 300 64-bit entries. You can enter the sdm access-list command
to change the maximum ACL database size, as shown in
Table 15-2 .
An example of this is shown in Example 15-2 .
Example 15-2 Configuring Entries for the ACL Region in TCAM
ML_Series# configure terminal
ML_Series(config)# sdm access-list 100
ML_Series(config)# end
Monitoring and Verifying SDM
To display the number of available TCAM entries, enter the show sdm size command from global
configuration mode:
ML_Series # show sdm size
Active Switching Database Region Maximum Sizes :
IP Adjacency : 300 64-bit entries
IP Prefix : 300 64-bit entries
QoS Classifiers : 300 64-bit entries
IP VRF Prefix : 300 64-bit entries
IP Multicast : 300 64-bit entries
MAC Addr : 8192 64-bit entries
Access List : 300 64-bit entries
Table 15-2 Partitioning the TCAM Size for ACLs
Task Command
sdm access-list number-entries Sets the name of the application region for which you want to
configure the size. You can enter the size as an absolute number
of entries.