Cisco 15327 - Manual (Page 472)

26-40
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 26 Configuring IEEE 802.17b Resilient Packet Ring
RI Configuration Example
Router#show interface rpr-ieee 0
RPR-IEEE0 is up, line protocol is up
Hardware is RPR-IEEE Channelized SONET, address is 0019.076c.7f72 (bia 0019.076c.7f72)
The MAC address of the secondary peer is 0019.076c.7f72. The configuration would now appear as
rpr-ieee ri mode 0019.076c.7f72.
Example 26-11 Primary ML-Series Card Configuration with Connection to Switch
interface rpr-ieee0
no ip address
rpr-ieee ri mode
rpr-ieee ri foreign
no shutdown
In the above example, after rpr-ieee ri mode you need to insert the MAC address of the primary peer. To
fetch this address, log in to the primary peer ML-Series card and enter the command show interface
rpr-ieee as follows:
Router#show interface rpr-ieee 0
RPR-IEEE0 is up, line protocol is up
Hardware is RPR-IEEE Channelized SONET, address is 0019.076c.7f73 (bia 0019.076c.7f73)
The MAC address of the primary peer is 0019.076c.7f73. The configuration would now appear as
rpr-ieee ri mode 0019.076c.7f73.
Example 26-12 Secondary ML-Series Card Configuration with Connection to Switch
interface rpr-ieee0
no ip address
rpr-ieee ri mode
rpr-ieee ri foreign
no shutdown
In the above example, after rpr-ieee ri mode you need to insert the MAC address of the secondary peer.
To fetch this address, log in to the secondary peer ML-Series card and enter the command show
interface rpr-ieee as follows:
Router#show interface rpr-ieee 0
RPR-IEEE0 is up, line protocol is up
Hardware is RPR-IEEE Channelized SONET, address is 0019.076c.7f74 (bia 0019.076c.7f74)
The MAC address of the secondary peer is 0019.076c.7f74. The configuration would now appear as
rpr-ieee ri mode 0019.076c.7f74.
Note In Figure 26-8 Cards A and C are primary cards, and B and D are secondary cards. Cards B and D are
peers. Therefore, to configure Card A’s MAC address, you need to configure Card B's RPR MAC
address. Similarly, to configure Card C’s MAC address, you need to configure Card D’s RPR MAC
address.
Example 26-13 Status of Redundant Interconnect can be found using
Router#sh ons dot17 ri
Redundant Interconnect Data
Mode: primary
State: standby
Peer: 0000.1111.2222
Peer Active: false