Modifying acl tcam size, Table 16-2 – Cisco 15327 User Manual
Page 251
16-5
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 16 Configuring Access Control Lists
Modifying ACL TCAM Size
Modifying ACL TCAM Size
You can change the TCAM size by entering the sdm access-list command. For more information on ACL
TCAM sizes, see the
“Configuring Access Control List Size in TCAM” section on page 15-3
.
provides an example of modifying and verifying ACLs.
Note
To increase the ACL TCAM size, you must decrease another region’s TCAM size, such as IP,
IP multicast, or L2 switching.
Caution
You will need to increase the TCAM size if you see the following error message:
Warning:Programming TCAM entries failed
Please remove last ACL command to re-activate ACL operation.
!
Please see the documentation to see if TCAM space can be
increased on this platform to alleviate the problem.
Example 16-1 Monitor and Verify ACLs
Router# show ip access-lists 1
Standard IP access list 1
permit 192.168.1.1
permit 192.168.1.2
Table 16-2
Applying ACL to Interface
Command
Purpose
ip access-group
{
access-list-number | name} {in | out}
Controls access to an interface.