Cisco 15327 - Manual (Page 504)

A-30
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
rpr-ieee tx-traffic rate-limit reserved rate [east | west]
rpr-ieee tx-traffic rate-limit reserved rate [east | west]
Use this command to limit the transmission rate of Class A0 reserved traffic on a specific (east or west)
span.
Syntax Description
Defaults The default is 0 Mbps.
Command Modes IEEE 802.17b based RPR interface configuration
Usage Guidelines A0 bandwidth is dedicated and cannot be reused for any other traffic, and thus should be assigned
cautiously. This command is specific to one span and would only be used if necessary to make a
distinction.
Examples In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee tx-traffic rate-limit reserved 5 east
Related Commands rpr-ieee tx-traffic rate-limit low [rate] {east | west}
rpr-ieee tx-traffic rate-limit medium [rate] {east | west}
rpr-ieee tx-traffic rate-limit high [rate] {east | west}
rpr-ieee tx-traffic rate-limit reserved [rate]
Parameter Description
east Pertains to configuration for eastbound span traffic.
west Pertains to configuration for westbound span traffic.
rate Value, expressed in Mbps, of the total bandwidth a station can use to
transmit Class A0 traffic onto a particular (east or west) span. Range is 0 to
1161 Mbps.