Cisco 15327 - Manual (Page 545)

A-71
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
show rpr-ieee rate detail
show rpr-ieee rate detail
Use this command to display the configured rate limits for each service class of traffic.
Syntax Description This command has no arguments or keywords.
Defaults N/A
Command Modes Privileged executive
Usage Guidelines Use this command to show the configured rates for Class A1, B-EIR, B-CIR, and reserved traffic.
Examples router# show rpr-ieee rate detail
Rate Limit Information for Interface RPR-IEEE0
West Span:
Reserved Bandwidth (Class A0): 0 Mbps
Rate Limiter High (Class A1): 20 Mbps
Rate Limiter Medium (Class B-CIR): 10 Mbps
Rate Limiter Low (Class B-EIR, C): full
East Span:
Reserved Bandwidth (Class A0): 0 Mbps
Rate Limiter High (Class A1): 20 Mbps
Rate Limiter Medium (Class B-CIR): 10 Mbps
Rate Limiter Low (Class B-EIR, C): full
Service Type: Relaxed
Idle Shaper is Enabled
Transmit at 500 packets per million when PTQ vacancy above 18432 bytes
Transmit at 250 packets per million when PTQ vacancy below 18432 bytes
Related Commands None