Cisco 15327 - Manual (Page 509)

A-35
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
show controller rpr-ieee interface-number [detail]
show controller rpr-ieee interface-number [detail]
Use this command to display the status of the IEEE 802.17b based RPR controller. Use the detail
argument to obtain additional SONET and RPR-IEEE information for the interface.
Syntax Description
Defaults N/A
Command Modes Privileged executive
Usage Guidelines This command can be used to help diagnose and isolate IEEE 802.17b based RPR or SONET problems.
Examples router# show controller rpr-ieee 0 detail
Interface RPR-IEEE0
Hardware is RPR-IEEE channelized SONET
RPR Interface Defects:
PROT ACTIVE = 0 MAX STATION = 0 MIS-CONF = 0 PASSTHRU = 1
EXCEED A0 RESERVED RATE: RINGLET 0 = 0 RINGLET 1 = 0
Active Alarms : None
Demoted Alarms: None
East Span (Ringlet0 TX Ringlet1 RX)
Framing Mode: GFP
Concatenation: VCAT
East Span Defects:
FS = 0 SF = 0 SD = 0 MS = 0
WTR = 0 MATCH = 0 KEEPALIVE = 0
LFD = 0 CSF = 0 UPI = 0
Active Alarms : None
Demoted Alarms: None
Alarms reportable to CLI: PAIS PLOP PUNEQ PTIM PPLM ENCAP PRDI PPDI BER_SF_B3 BER_SD_B3
VCAT_OOU_TPT LOM SQM
*************** VCG ***************
VCG State: VCG_NORMAL
LCAS Type: SW-LCAS
Defect Processing Mode: IMMEDIATE
PDI Holdoff Time: 100 (msec)
Active Alarms : None
Demoted Alarms: None
DEGRADED = 1 DOWN = 1 LOA = 1
*************** Member 0 ***************
ESM State: IS
VCG Member State: VCG_MEMBER_NORMAL
PAIS = 0 PLOP = 0 PRDI = 0 PTIM = 0
PPLM = 0 PUNEQ = 1 PPDI = 0 PTIU = 0
BER_SF_B3 = 0 BER_SD_B3 = 0 BIP(B3) = 30 REI = 0
Parameter Description
interface-number Number of the IEEE 802.17b based RPR interface (0–1)
detail Greater detail per interface.