Cisco 15327 - Manual (Page 169)

11-11
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 11 Configuring Networking Protocols
Configuring OSPF
Figure 11-1 shows an example of an IP routing protocol using OSPF.
Figure 11-1 IP Routing Protocol Example Using OSPF
Enabling OSPF requires that you create an OSPF routing process, specify the range of IP addresses to
be associated with the routing process, and assign area IDs to be associated with that range.
Timers shortest path first (spf) spf delay: 5 seconds.
spf-holdtime: 10 seconds.
Virtual link No area ID or router ID defined.
Hello interval: 10 seconds.
Retransmit interval: 5 seconds.
Transmit delay: 1 second.
Dead interval: 40 seconds.
Authentication key: No key predefined.
MD5: No key predefined.
Table 11-2 Default OSPF Configuration (continued)
Feature Default Setting
ONS 15454
with ML100T-12
ONS 15454
with ML100T-12
Fast Ethernet 0
192.168.1.1/24
POS 0 POS 0
Fast Ethernet 0
192.168.3.1/24
ML_Series_A 192.168.2.1/24 ML_Series_B 192.168.2.2/24
OSPF Area
78971
SONET/SDH