Cisco 15327 - Manual (Page 309)

18-17
Ethernet Card Software Feature and Configuration Guide, R7.2
Chapter 18 Configuring Ethernet over MPLS
MPLS-TE Configuration Example
no mpls traffic-eng auto-bw timers frequency 0
!
!
!
interface Loopback0
ip address 222.222.222.222 255.255.255.255
!
interface Tunnel0
ip unnumbered Loopback0
tunnel destination 212.212.212.212
tunnel mode mpls traffic-eng
tunnel mpls traffic-eng autoroute announce
tunnel mpls traffic-eng path-option 1 explicit identifier 1
!
interface Tunnel1
ip unnumbered Loopback0
tunnel destination 212.212.212.212
tunnel mode mpls traffic-eng
tunnel mpls traffic-eng autoroute announce
tunnel mpls traffic-eng path-option 2 explicit identifier 2
!
interface GigabitEthernet0
no ip address
shutdown
!
interface GigabitEthernet1
no ip address
!
interface GigabitEthernet1.1
encapsulation dot1Q 10
fcs-preservation-on
mpls l2transport route 212.212.212.212 222
!
interface GigabitEthernet1.2
encapsulation dot1Q 20
mpls l2transport route 212.212.212.212 223
!
interface GigabitEthernet1.3
encapsulation dot1Q 30
mpls l2transport route 212.212.212.212 224
!
interface POS0
ip address 170.170.170.172 255.255.255.0
mpls traffic-eng tunnels
tag-switching ip
ip rsvp bandwidth 10000
!
interface POS1
ip address 2.1.1.22 255.255.255.0
mpls traffic-eng tunnels
tag-switching ip
ip rsvp bandwidth 10000
!
router ospf 1
mpls traffic-eng router-id Loopback0
mpls traffic-eng area 0
log-adjacency-changes
network 2.1.1.22 0.0.0.0 area 0
network 170.170.170.172 0.0.0.0 area 0
network 222.222.222.222 0.0.0.0 area 0
!
ip classless
no ip http server
!