Cisco 15327 - Manual (Page 499)

A-25
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
[no] rpr-ieee ri {primary | secondary} peer peer-MAC-address
[no] rpr-ieee ri {primary | secondary} peer peer-MAC-address
Use this command to set the mode for the IEEE 802.17b based RPR interface and the peer address, or
disables the feature. Use the no form to disable the feature.
Syntax Description
Command Default The default is disabled.
Command Modes IEEE 802.17b based RPR interface configuration
Usage Guidelines The peer MAC address is in hexadecimal format. If you change the MAC address, you must repeat this
command with the new address.
In this command, interface can be shortened to int. It is not necessary to use the RI term if you are
specifically indicating a primary or secondary peer, as in the following example.
Examples In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee ri mode primary peer 00.24.A4.0E.9A.68
Related Commands rpr-ieee ri {primary | secondary} delay interval
Parameter Description
primary Single traffic queue mode.
secondary Dual traffic queue mode.
peer-MAC-address The MAC of the alternate station. For a primary station, this command
enters the MAC address of the secondary station. For a secondary station,
this command enters the primary station MAC address.