Cisco 15327 - Manual (Page 481)

A-7
Ethernet Card Software Feature and Configuration Guide, R7.2
Appendix A Command Reference
[no] pos pdi holdoff time
[no] pos pdi holdoff time
Use this command to specify the time, in milliseconds, to hold off sending the path defect indication
(PDI) to the far end when a virtual concatenation (VCAT) member circuit is added to the virtual
concatenation group (VCG). Use the no form of the command to use the default value.
Syntax Description
Defaults The default value is 100 milliseconds.
Command Modes Interface configuration mode (packet-over-SONET/SDH [POS] only)
Usage Guidelines This value is normally configured to match the setting on the peer terminal equipment (PTE). The time
granularity for this command is 1 millisecond.
Examples In this example, interface is shortened to int.
Gateway(config)# int pos0
Gateway(config-if)# pos pdi holdoff 500
Related Commands pos trigger defects
Parameter Description
time Delay time in milliseconds, 100 to 1,000