beautypg.com

Eigrp, Ospf – Cisco 15327 User Manual

Page 160

background image

11-2

Ethernet Card Software Feature and Configuration Guide, R7.2

Chapter 11 Configuring Networking Protocols

RIP

RIP

To configure the Routing Information Protocol (RIP), perform the following procedure, beginning in
global configuration mode:

EIGRP

To configure the Enhanced Interior Gateway Routing Protocol (EIGRP), perform the following
procedure, beginning in global configuration mode:

OSPF

To configure the Open Shortest Path First (OSPF) protocol, perform the following procedure, beginning
in global configuration mode:

Command

Purpose

Step 1

Router(config)# router rip

Enters router configuration mode, defines RIP as the
routing protocol, and starts the RIP routing process.

Step 2

Router(config-router)# network

net-number

Specifies a directly connected network based on the
Internet Network Information Center (InterNIC) network
number—not a subnet number or individual address. The
routing process associates interfaces with the appropriate
addresses and begins processing packets on the specified
network.

Step 3

Router(config-router)# exit

Returns to global configuration mode.

Command

Purpose

Step 1

Router(config)# router eigrp

autonomous-system-number

Defines EIGRP as the IP routing protocol.

The autonomous system number is the
autonomous system to which this ML-Series card
belongs.

Step 2

Router(config-router)# network

net-number

Defines the directly connected networks that run
EIGRP.

The network number is the number of the network
that is advertised by this ML-Series card.

Step 3

Router(config-router)# exit

Returns to global configuration mode.