TeeJet TASC-6100 - Manual (Page 9)

1-3
98-05018
R2
TASC 6100
Switches& Cont.
CE & S TANDARD V ERSION
INC.
5 6 7 8 9
MID-TECH
®
MPH
1 2 3
BOOMS
OFF DEC.
4
CH
®
OFF
ON
MIDWEST TECHNOLOGIES, INC.
SET- UP
OPERATE
5 6 7 8 9
MPH
1 2 3
BOOMS
OFF DEC.
4
OFF
MIDWEST TECHNOLOGIES, INC.
Rate Controller
TASC-6100
%Rate
DISPLAY SELECTOR
Speed
Area Width
Distance
Fan RPM
Test
Speed
PSI/Prime
Total Applied
Product Vol. Appl. Rate
Scan
%Rate
DISPLAY SELECTOR
Speed
Area Width
Distance
Fan RPM
Test
Speed
PSI/Prime
Total Applied
Product Vol. Appl. Rate
Scan
SET- UP
OPERATE
% Rate: The percent
of programmed
application rate
at which the
system is apply-
ing product.***
Application Rate:
Displays the
target application
rate when the
ground speed is
zero or all booms
are OFF.** The
actual application
rate is displayed
here once
application has started.
Total Applied: The total volume of product applied
since the last time the counter was reset, as
measured by the pressure sensor or flow meter.*
Impl. Width: The active boom width, (total of all
boom sections turned ON).
Distance: The total distance traveled since the last
time the counter was reset.
PSI/Prime: Used to open the control valve during
product pump priming, for fast unload, and to
display boom pressure when operating in pressure
based mode.
Test Speed: The speed the console uses for stationary
tests of the sprayer.**
Scan: The display scans Speed, Area #1, Product
Vol., Application Rate, Total Applied, and Fan
RPM, stopping at each position for approximately
two seconds before automatically cycling to the
next.
* Totals can be zeroed in
this mode.
** Values are programmable
in this mode.
*** Values changeable by a %
increase or decrease.
Fig. 1-2. Display Selector
Functions - Operate Mode