TeeJet TASC-6100 - Manual (Page 10)

1-4
TASC 6100 98-05018
R2
CE & S TANDARD V ERSION
* Totals can be zeroed in
this mode.
** Values are programmable
in this mode.
*** Values changeable by a %
increase or decrease.
INC.
5 6 7 8 9
MID-TECH
TASC-6100
Rate Controller
®
MPH
1 2 3
BOOMS
OFF
%Rate
DISPLAY SELECTOR
Speed
Area Width
Distance
Fan RPM
Test
Speed
PSI/Prime
Total Applied
Product Vol. Appl. Rate
Scan
DEC.
4
ON
SET- UP
OPERATE
%Rate
DISPLAY SELECTOR
Speed
Area Width
Distance
Fan RPM
Test
Speed
PSI/Prime
Total Applied
Product Vol. Appl. Rate
Scan
MIDWEST TECHNOLOGIES, INC.
SET- UP
OPERATE
Display Selector - Setup Mode (Liquid)
(See Fig. 1-3)
Speed: Ground speed
override (GSO) value.**
Area: Area Accumulator
#2. The total area treated
since the counter was last
reset.*
Fan RPM: The current fan
RPM. calibration number.
Since not used in liquid
mode, can be set to zero to remove the fan
RPM reading from the scan feature.**
Product Volume: Used to set the full load value of the
vehicle.**
% Rate: The percent rate change value (the percent
by which the programmed application rate can be
changed with each activation of the INC/DEC
switch).**
Application Rate: Psi mode - A flow sensor cal. #
correction factor that allows for corrections due to
differences in product viscosities without changing
the base cal. #. STnrd and rEFLO modes - ERR, No
function in this mode.
Total Applied: The pressure sensor or flow meter
calibration number. NOTE: Must have all booms
ON when in REFLOW Mode.**
Width: Individual boom section widths. The display
cycles through the individual boom sections, in
order, unless a particular boom switch is activated
and the boom master switch is ON.**
Distance: The current distance calibration number.**
PSI/Prime: The current console operating mode.**
Test Speed: The current test speed.**
Scan: ERR, No function in SETUP mode.
Fig. 1-3. Display Selector
Functions - Set-Up Mode