TeeJet TASC-6100 - Manual (Page 20)

2-4
TASC 6100
98-05018
R2
CE & S
TANDARD
V
ERSION
change in the target rate). For example, with the applica-
tion rate set to 10.0 gallons per acre, a single actuation of
the INC. switch causes the system to control flow at the
rate of 12.0 gallons per acre (10.0 + 20% = 12.0).
A. Set the console switches to the following positions:
1. Power ON
2. Mode Selector SET-UP
3. Display Selector % Rate
The display shows the current % change value.
B. Use the INC./DEC. switch to set this number to the
desired % change value.
S ETTING B OOM W IDTHS
T
he MID-TECH control console is designed to
automatically compensate for changes in the swath
width, caused by turning boom sections on or off.
To accurately respond to changes in swath width, the
console must know the length of each boom section. Use
the following procedure to set boom section widths.
A. Set the console to the following positions;
1. Power ON
2. Mode Selector SET- UP
3. Display Selector Impl. Width
4. Boom switches OFF
(or Master switch)
The display cycles through each boom position (1
through 9) and displays its current width in inches
(meters).
B. As each boom position appears on the display, use
the INC./DEC. switch to set the display to the
number of inches (meters) covered by that boom.
Repeat for each section.
C. Set all unused boom sections to a width of zero “0”
inches (meters). This insures that accidentally
turning a boom switch ON doesn’t affect the control
console. (An ERROR 0 Boom # will then result if an
unused boom gets accidentally turned on)
DISPLAY SELECTOR
Speed
Area Impl. Width
Distance
Test
Speed
PSI/Prime
Total Applied
Application Rate
OFF SET- UP DEC.
ON OPERATE INC.
Scan
Product Vol.
Fan RPM
BOOMS
1 2 3 4 5 6 7 8 9
% Rate
A-1
A-2
A-3
B
DISPLAY SELECTOR
Speed
Area Impl. Width
Distance
Test
Speed
PSI/Prime
Total Applied
Application Rate
OFF SET- UP DEC.
ON OPERATE INC.
Scan
Product Vol.
Fan RPM
BOOMS
1 2 3 4 5 6 7 8 9
% Rate
A-1
A-2
A-3
B, C, D, E E
MASTER
ON OFF MI
A-4
E