TeeJet TASC-6100 - Manual (Page 26)

2-10
TASC 6100
98-05018
R2
CE & S
TANDARD
V
ERSION
than the pre-selected GSO Speed, the console will sound
an alarm and the display will flash a “Too Slow”
message to warn the operator of possible over applica-
tion.
P
RODUCT
V
OLUME
(F
ULL
L
OAD
V
ALUE
)
Setting the Full Load Value
The Full Load Value of the vehicle can be preset into the
console and automatically recalled when the vehicle is
reloaded.
Use the following procedure to set the Full Load Value
into the console.
A. Set the console to the following switch settings:
1. Power ON
2. Mode Selector SET-UP
3. Display Selector Product Vol.
4. Boom switches OFF
(or Master switch)
The display shows the current Full Load Value.
B. Use the INC./DEC. switch to set the desired Full Load
Value.
Recalling the Full Load Value
When Product Vol. and OPERATE mode are selected,
the Full Load Value of the vehicle can be recalled by
holding the INC. switch up for at least three seconds.
Setting a Load Value Less than Full Load
If a full load is not taken aboard the vehicle, the actual
amount loaded can be set without changing the Full Load
Value. First recall the Full Load Value as explained in the
previous section, then use the INC./DEC. switch to set the
actual volume loaded into the tank.
OFF SET- UP DEC.
ON OPERATE INC.
BOOMS
1 2 3 4 5 6 7 8 9
Recall & Set
Set
Recall
Recall & Set Recall & Set
DISPLAY SELECTOR
Speed
Area Impl. Width
Distance
Test Speed
PSI/Prime
Total Applied
Application Rate
Scan
Product Vol.
Fan RPM
% Rate
DISPLAY SELECTOR
Speed
Area Impl. Width
Distance
Test
Speed
PSI/Prime
Total Applied
Application Rate
OFF SET- UP DEC.
ON OPERATE INC.
Scan
Product Vol.
Fan RPM
BOOMS
1 2 3 4 5 6 7 8 9
% Rate
A-1
A-2
A-3
C
MASTER
ON OFF MI
B