TeeJet TASC-6100 User Manual

Page 47

3-5

TASC 6100

Operate

CE & S

TANDARD

ERSION

98-05018

D. When the vehicle hydraulics are engaged, the

conveyor operates at maximum speed. This
procedure is useful for rapid unloading of the
vehicle.

E. To return to normal operation, hold the INC./

DEC. switch down for three to five seconds or
move the Display Selector switch away from the
PSI/Prime position.

Ground Speed Override (GSO)

n optional Ground Speed Override switch
can be used to allow temporary operation
using the "GSO Speed" instead of the actual

speed registered by the ground speed sensor (see page
2-9). The override feature is used to bring the
applicator up to rate quickly when starting from a
complete stop or to maintain an adequate pattern
when the vehicle is operating at very low ground
speeds.

The TASC 6100 operates normally when the Ground
Speed Override switch is in the OFF (open) condi-
tion. (If you do not have a GSO switch, the short-
ing connector must be in place in the Boom
Interface cable connector labled “GSO”.) This
feature can then be disabled by setting the GSO speed
to zero.

When the Override switch is ON (closed), and the
actual ground speed is less than the GSO speed, the
console automatically uses the "GSO speed" value to
control application rate. If the actual ground speed
increases above the preset GSO speed, the control
console reverts to controlling application rate on the
basis of the actual ground speed.