TeeJet TASC-6100 - Manual (Page 11)

1-5
98-05018
R2
TASC 6100
Switches& Cont.
CE & S TANDARD V ERSION
Display Selector - Operate Mode (Gran.)
(See Fig. 1-2)
Speed: The current vehicle speed.
Area: Area Accumulator #1. The total area treated
since the counter was last reset.*
Fan RPM: The current speed of the fan (spinners).
Product Vol.: Amount of product aboard the ve-
hicle.**
% Rate: The percent of programmed application rate
at which the product is being applied.***
Application Rate: Displays the target application rate,
when the ground speed is zero or all booms are
OFF. ** Once application begins, the actual
application rate is displayed here.
Total Applied: The total volume applied since the
accumulator was last reset, as measured by the rate
sensor.*
Impl. Width: The active spread width, (total of all
spreader sections turned “ON”).
Distance: The total distance traveled since the last
time the counter was reset.
Prime: Used to open the control valve. It can be used
in the granular application to unload the vehicle at
its maximum discharge rate.
Test Speed: The speed the console uses for stationary
tests of the spreader.**
Scan: The display scans Speed, Area #1, Product
Volume, Application Rate, Total Applied, and Fan
RPM (if Fan RPM Cal # not set to zero). The
display stops at each position for approximately
two seconds before automatically cycling to the
next.
* Totals can be zeroed in
this mode.
** Values are programmable
in this mode.
*** Values changeable by a %
increase or decrease.