TeeJet TASC-6100 - Manual (Page 36)

2-20
TASC 6100
98-05018
R2
CE & S
TANDARD
V
ERSION
The calibration number can also be calibrated based on
field experience.
G
RANULAR
O
NLY
S
ET
-U
P
V
erify that the correct application program has
been selected. (see page 2-1)
S
ETTING
T
HE
P
RODUCT
D
ENSITY
(for granular applications only.
6
he Product Density must be entered into the
TASC 6100 for the console to accurately control
the application rate.
Product density is entered as pounds per cubic foot (Lb /
Ft
3 ) in US units and kilograms per tenths of a cubic meter
(Kg / 0.1m 3 ) in Metric units. Product Density should be
measured and entered frequently to ensure accurate
application.
A. Set the console to the following positions:
1. Power ON
2. Mode Selector SET-UP
3. Display Selector Application Rate
The current product density is displayed.
B. Use the INC./DEC. switch to set the display to the
desired density.
S
ETTING THE
F
AN
T
ACH
C
AL
. #
T
he TASC 6100 console includes a Tach port that
allows you to monitor the speed of the fan (spin
ner) on a granular spreader. For the console to
accurately measure the fan (spinner) RPM, the number of
pulses generated by the fan RPM sensor for each revolu-
DISPLAY SELECTOR
Speed
Area Impl. Width
Distance
Test
Speed
PSI/Prime
Total Applied
Application Rate
OFF SET- UP DEC.
ON OPERATE INC.
Scan
Product Vol.
Fan RPM
BOOMS
1 2 3 4 5 6 7 8 9
% Rate
A-2
B
A-3
A-1
L Psi (bAr) Mode - Material left over - Adj. Cal. # down slightly
- Short of material - Adj. Cal. # up slightly
L STnrd Mode - Material left over - Adj. Cal. # up slightly
- Short of material - Adj. Cal. # down slightly