TeeJet TASC-6100 User Manual
Page 55
5-3
98-05018
R2
TASC 6100
Er
ro
rs
CE & S
TANDARD
V
ERSION
Check cables, from “Flow
Control” port on back of
console, to valve for bad
connections, abrasions, and
pinched or broken wires.
Check for blown fuses
Check cables, from “Boom
Interface” port on back of
console, to valves for bad
connections, abrasions, and
pinched or broken wires.
Check for blockage of the
flow meter rotor.
Check cables, from “Flow
Control” port on back of
console, to flowmeter for bad
connections, abrasions, and
pinched or broken wires.
Contact your MID-TECH
dealer if you see this message
on a TASC 6100 controller.
Check “Flow Control”
connections on the back of
the console. Secure if loose.
Check in-line fuse (optional)
near positive
battery connection.
Check valve control signals.
Check cables, from “Flow
Control” port on back of
console, to valve, for bad
connections, abrasions, and
pinched or broken wires.
Consult Operator's Manual
for the correct switch
sequence.
Err 3
Pump L
(Cont.)
Err 4
Err 5
Pump L
Err
Boom valves are not opening.
Flow in the product line.
Not a diagnostic function in
the TASC 6100.
Application rate is exceeding
the target rate by 15%. Valve
is not responding.
Often caused by loss of power
to valve.
Incorrect switch sequence is
selected on the console.