TeeJet TASC-6100 - Manual (Page 12)

1-6
TASC 6100 98-05018
R2
CE & S TANDARD V ERSION
Display Selector - Set-Up Mode (Gran.)
(See fig. 1-3)
Speed: Ground Speed Override (GSO) value.**
Area: Area Accumulator #2. The total area treated
since the counter was last reset.*
Fan RPM: The current fan RPM calibration
number. This cal # can be set to zero to remove the
fan RPM reading from the scan feature.**
Product Volume: Used to set the full load capacity of
the vehicle.**
% Rate: The percent rate change value (the percent
by which the programmed application rate can be
changed with each activation of the INC/DEC
switch).**
Application Rate: Product density.**
Total Applied: The rate sensor calibration number
[spreader constant].**
Width: Individual boom section widths.**
Distance: The current distance calibration number.**
Prime: The current console operating mode.**
Test Speed: The current test speed.**
Scan: Err, No function in the SETUP mode.
I
MPLEMENT
S
TATUS
I
NPUT
A
n external “Implement Status” input can be
used to override the TASC control. The
input must present a positive voltage (+12.0
VDC) on the boom interface cable sense line. As long
as this condition is present, the control console
operates normally. If the voltage is interrupted, the
control console automatically stops applying. At the
same time, the control console will either "HOLD" or
* Totals can be zeroed in
this mode.
** Values are programmable
in this mode.
*** Values changeable by a %
increase or decrease.