TeeJet TASC-6100 - Manual (Page 19)

2-3
98-05018
R2
CE & StandardVersion
TASC 6100
Setup
& Cal.
Setting the APPLICA-
TION RATE to 0.0 will
turn off the flow
control function.
DISPLAY SELECTOR
Speed
Area Impl. Width
Distance
Test
Speed
PSI/Prime
Total Applied
Application Rate
OFF SET- UP DEC.
ON OPERATE INC.
Scan
Product Vol.
Fan RPM
BOOMS
1 2 3 4 5 6 7 8 9
% Rate
A-1
A-2
A-3
B
Alt.-Rate
Standard Rate
OFF A-4
DISPLAY SELECTOR
Speed
Area Impl. Width
Distance
Test
Speed
PSI/Prime
Total Applied
Application Rate
OFF SET- UP DEC.
ON OPERATE INC.
Scan
Product Vol.
Fan RPM
BOOMS
1 2 3 4 5 6 7 8 9
% Rate
A-1
A-2
A-3
B
Alt.-Rate
Standard Rate
OFF
A-4
L
IQUID
/G
RANULAR
C
OMMON
S
ETUP
I
TEMS
S
ETTING
A
PPLICATION
R
ATES
T
he TASC 6100 system is designed to maintain a
constant, pre-selected application rate. In order for
the control console to do this, the operator must
enter the desired application rate. Two, switch selectable,
rates can be pre-programmed into the console.
Standard Rate
A. Set the console switches to the following positions:
1. Power ON
2. Mode Selector OPERATE
(A
PPLICATION RATE IS SET IN THE
O
PERATE
M
ODE
!!!)
3. Display Selector Application Rate
4. Rate switch Standard Rate
The display shows the current application rate.
B. Use the INC./DEC. switch to set the desired rate.
Alternate Rate
C. Set the console switches to the following positions:
1. Power ON
2. Mode Selector OPERATE
(A PPLICATION RATE IS SET IN THE O PERATE M ODE !!!)
3. Display Selector Application Rate
4. Rate switch Alt.- Rate
The display shows the current application rate.
D. Use the INC./DEC. switch to set the desired rate.
S ETTING THE % R ATE C HANGE
T
his feature allows the operator to change the
application rate “ON THE GO” with a simple
actuation of the INC./DEC. switch. The amount of
change each switch actuation makes is proportional to
the value programmed into this position, (e.g. 20 =20%