PRG V676 User Manual 3.5 - Manual (Page 96)

78 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
From Keypad
Channels may also be selected using the command-line keypad, available on the front panel.
Guidelines:
+ Any combinations of [ + ], [ - ], and [Thru] are
allowed.
+ Pressing [Enter] completes the channel selection.
+ Because the keypad always defaults to channel
entry mode, use of the [Chan] (channel) button is
optional.
Select a single channel:
+ [n] [Enter].
Select multiple channels:
+ [m] [+] [n] [Enter].
Select a range of channels:
+ [m] [Thru] [q] [Enter].
Select multiple channels including a group:
+ [m] [+] [Group] [n] [Enter].
Select all active channels:
+ [Chan] [Enter].
Other examples:
+ [m] [+] [s] [Thru] [w] [Enter].
+ m] [+ ] [s] [Thru] [w] [-] [t] [Enter].
[Clear]
[Clear] functions as a backspace key when used during command-line construction. For example, [n] [Thru]
[t] [Clear] [s] [Enter] results in the selection of channels n thru s. When [Clear] is used after an [Enter] (fully terminated
command line), the command line is cleared.
The only thing that clears a syntax error on the command line is [Clear]. Any other keypad entry is ignored until the
error condition is cleared.
Holding down [Clear] will clear an entire unterminated command line.
Note: The order of channel selection is retained when storing a Group. Refer to "Ordered Groups" on page 151.
+ -
9 8 7
4 5 6
3 2 1
. 0
Store
Sel
Store
Recall
Label
Delete
Update Grab
Track/
Fill
Park/
Unpark
Undo Patch
Sneak Help
Copy/
Move ?
Cue Chan Dimmer
Board
Cue Macro Snap
Shot
Preset Color Beam
Effect Set Seq
Group Dynam Step Clear
Link Loop Out
Time
Wait Trail Rate
Time Block Sub
Delay Speed
At Full Enter
Thru
Cmd
Option
Shift
ready (channel)
Tip