Intensity – PRG V676 User Manual 3.5 User Manual
Page 116

98
V676
®
/ V476
®
CONTROL CONSOLE USER MANUAL
Intensity
The keypad can be used to adjust the brightness of the luminaire’s beam. Intensity responds to a percentage value of
0-100.
The [At] button is used to enter intensity values:
+
+
The [Full] button is used to quickly set intensity to 100%.
+
The [+] and [-] buttons can be used in combination with the [At] button to increment or decrement a current intensity
value by a specific amount. For example, if the current intensity value is 50%:
+
+
To quickly enter an intensity below 91%, but divisible by 10, use only the first digit of the desired level (for
example, [At] [5] = 50%).
To Mark a channel on the command line, enter the following sequence:
+
[Chan] [n] [At] [At] [Enter]
Tip