Sneak value or percent, Direct sneak to parameters, Sneak value or percent direct sneak to parameters – PRG V676 User Manual 3.5 User Manual
Page 140
122
V676
®
/ V476
®
CONTROL CONSOLE USER MANUAL
Sneak Value or Percent
Sneaks can be done by value or by percentage using either the command-line or direct-entry methods.
Using Command Line
When using the command line, the type of entry (Value or Percent) is based on the Parameter setting in the console
Settings/General window. Refer to
on page 328. In this case, enter a sneak command as usual, such as
[Sneak] [#] [Enter] - where the # is either a value or percentage based on the Parameter setting.
Using Encoder Sidebar
When using the Encoder Sidebar, press a parameter. At the numeric keypad, select either Value or Percent by
pressing the appropriate button.
Direct Sneak To Parameters
Direct sneak to parameters is possible by holding [Sneak] while pressing a parameter in the Encoder Sidebar.
Value or Percent Buttons
Numeric Keypad
Encoder Sidebar
Press and hold
[Sneak] button
while touching
parameter.
Encoder Sidebar