Submaster direct mode – PRG V676 User Manual 3.5 User Manual
Page 303
V676
®
/ V476
®
CONTROL CONSOLE USER MANUAL
285
Submaster Direct Mode
To assist in updating or re-storing cues, it is possible to have the command-line track the sequence of cues being
executed in a submaster. When Submaster Direct mode is active, cues will advance according to the sequence being
played back in the specified submaster.
There are two methods of initiating this mode:
+
At command-line keypad, press [Cue] [Sub] [n] [Enter] - where n is the desired submaster number.
+
At command-line keypad, press and hold [Cue] while choosing a submaster. ("Choose" is activated by touching
the specific submaster on the touchscreen.)
Once the mode has been activated, the cue title will show "Synced to sub #". Any advances in the cue sequence at
the submaster will automatically advance the current cue. If you wish to make changes to any cue, then that cue
number is already in the display when you go to store the cue again (after making changes).
There are two options for turning off the Submaster Direct mode (this will unlock all submasters):
+
Enter the command-line sequence [Cue] [Sub] [0] [Enter] to turn off Direct mode on
all
submasters.
+
Press and hold [Cue] while pressing "choose" area on any submaster that is in Direct mode to turn off Direct
mode on
all
submasters.
Sync Information
Press both arrows
together to resync