PRG V676 User Manual 3.5 - Manual (Page 131)

V676 ® / V476 ® CONTROL CONSOLE USER MANUAL 113
Set intensity delay time:
Intensity timing can have two values: one which controls the intensity transition if the intensity is fading to a higher
level (up time) and one which controls the transition if the intensity is fading to a lower level (down time).
Step 1. Select channels as required.
Step 2.

INTENSITY

[Time] [1] [.] [0] [Delay] [.] [5] [Enter] - sets the up and down times to 1 second, with a one-half
second delay.
Set intensity up or down time:
Step 1. Select channels as required.
Step 2. Select

Up

or

Down

to select one individually, then press [Time] [1] [.] [2] [Enter] - sets the up or down
fade time to 1.2 seconds.
Set intensity up and down time while storing a cue:
For this shortcut, the first Time entered is always Up and the second is Down.
Step 1. Select channels as required.
Step 2. Ensure all parameters at Timing screen are deselected.
Step 3. Press [Store] [Cue] [x] [Time] [m] [Time] [n] [Enter] - stores Cue x with an up time of m and a down time of n.
Set timing back to zero:
Step 1. Select channels as required.
Step 2. At Timing Filter, select a parameter.
Step 3. Press [Time] [0] [Enter].
Time and delay values stay in a luminaire until changed or set back to zero. Use the Luminaire Status window
with time (
) selected to view current timing and delays. To clear delay timing, select channel and
appropriate parameters in the Timing window and set delay to 0. (Refer to "Luminaire Status Window" on
page 99.)
Tip