PRG V676 User Manual 3.5 - Manual (Page 186)

168 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
PLAYING BACK CUES
Basic Playback
After storing a cue, it can be played back using a submaster.
Play a cue:
Step 1. At keypad, press [Cue] [n] [Enter] or scroll through cue list to select cue. It will be displayed in the keypad
window.
Step 2. At required submaster, press [Select] to select
submaster for playback function.
Step 3. Press [Load] to place cue in pending file (as shown
in submaster display).
Step 4. Set Grand Master fader at required level.
Step 5. Set submaster fader at required level.
Step 6. Press [Go] to play cue.
Play next cue:
The submaster always sequences, placing the next sequential
cue from the cue sheet or any linked cue in its pending file.
Linked cues without wait times will await manual execution.
+ Press [Go] again to play next cue.
Play previous cue:
+ Press [Back] to play previous cue (previously active on
that submaster). Subsequent presses of [Back] will step
backwards through cue sheet.
Play a cue again:
+ Press [Run] to play active cue again.
Shortcut to make a cue active in an empty submaster: at keypad press [cue number], then at submaster
press [Go]. (Must be valid cue number.)
set cue 1
Cue 1 *
1
Select
Load
Run
Stop/
Step
Back
Go
Solo
Bump
Loads cue
Plays active cue
Plays pending cue
Plays last cue
Scales intensity
Active cue
Pending cue
Stops/Steps through cues
Selects submaster
Submaster Fader
Momentary submaster select
(all others go to zero)
Advanced
Attributes
Status:
R = running
S = stopped
Tip