PRG V676 User Manual 3.5 - Manual (Page 260)

242 V676 ® / V476 ® CONTROL CONSOLE USER MANUAL
CITP: Controller, Interface, Transport, Protocol
Use the following procedure to connect a Vx76 console to an Mbox Extreme Media Server.
Important Notes:
+ Before starting, make sure you have the latest version of the Mbox Daemon, as well as the Mbox Extreme version
that matches the Daemon.
+ When the Mbox Extreme application is launched, it will atomically launch the Mbox Daemon application. You can
confirm that Mbox Daemon is running by pressing [
 D] (while Mbox Extreme server is in Window mode).
To connect a Vx76 console to an Mbox Extreme server:
Step 1. At Mbox Extreme server, verify Mbox Daemon version and make sure Ethernet 2 is enabled at Network
Interface pull-down bar.
Step 2. At MSEX pull-down bar, select version 1.0. (The Commands pull-down bar is not needed for this
procedure.)
Step 3. Verify Mbox Extreme version and launch application.
Step 4. At Mbox Extreme main window, click on Setup tab.