Moniteur 50 Series SMART Positioners - Manual (Page 65)

Operation
4-3
Positioner SIPART PS2/SIPART PS2 PA
C79000-G7476-C150–01
With the mode button you can switch from automatic or manual mode
to “Configuring” mode (see Fig. 4-2). To do this press the button for at
least 5 seconds until switchover has been completed.
In “Configuring” mode you can change the parameter values of the po-
sitioner.
The upper line of the display shows the current parameter value, the
lower the parameter name (in abbreviated form) and the parameter
number.
You can select the next parameter with the mode button. If you keep
the mode button pressed (< 5 s) while at the same time pressing the
decrement button you can select parameters in the reverse order.
You can change the parameter value with the decrement and increment
buttons.
(simultaneously) (simultaneously)
(simultaneously) (simultaneously)
> 5 s
to
Fig. 4-3 Overview: Configuring
4.4 Parameters
There follows a list of all parameters of the positioner.
❑ SIPART PS2: from p. 4-4 on
❑ SIPART PS2 PA: from p.4-13 on
The parameter name is shown both as printed text and as shown on
the display. In the “Function” column the function of the parameter is
described briefly. The possible parameter values, the physical unit and
the factory settings of the parameters are also shown.
Configuring