Moniteur 50 Series SMART Positioners - Manual (Page 112)

A-4
Positioner SIPART PS2/SIPART PS2 PA
C79000-G7476-C150–01
;**********************************************************
;** GSD Datei fuer SIPART PS 2 PA, SIEMENS AG **
;** MLFB: 6DR410x–xx **
;** Stand: 30.10.98 **
;** Datei: SIS18079.GSD **
;**********************************************************
;
#Profibus_DP
GSD_Revision = 1
Vendor_Name = ”SIEMENS AG”
Model_Name = ”SIPART PS 2”
Revision = ”V1.0”
Ident_Number = 0x8079
Protocol_Ident = 0
Station_Type = 0
FMS_supp = 0
Hardware_Release = ”A01”
Software_Release = ”Z01”
31.25_supp = 1
45.45_supp = 1
93.75_supp = 1
MaxTsdr_31.25 = 100
MaxTsdr_45.45 = 250
MaxTsdr_93.75 = 1000
Redundancy = 0
Repeater_Ctrl_Sig = 0
24V_Pins = 0
Bitmap_Device = ”SIS8079n”
Freeze_Mode_supp = 0
Sync_Mode_supp = 0
Auto_Baud_supp = 0
Set_Slave_Add_supp = 1
Min_Slave_Intervall = 250
Modular_Station = 0
Max_Module = 1
Fail_Safe = 0
Slave_Family = 12
Max_Diag_Data_Len = 14
Implementation_Type = ”SPC41/ITEC”
;––––––– Bedeutung der geraetebezogenen Diagnosebits: –––––––––
;
Unit_Diag_Bit(24) = ”Hardware failure electronics”
Unit_Diag_Bit(25) = ”Hardware failure mechanics”
Unit_Diag_Bit(28) = ”Memory error”
Unit_Diag_Bit(29) = ”Measurement failure”
Unit_Diag_Bit(30) = ”Device not initialized”
Unit_Diag_Bit(31) = ”Device initialization failed”
Unit_Diag_Bit(32) = ”Zero point error”
Unit_Diag_Bit(33) = ”Power supply failed”
Unit_Diag_Bit(34) = ”Configuration invalid”
Unit_Diag_Bit(35) = ”Restart”
Unit_Diag_Bit(36) = ”Coldstart”
Unit_Diag_Bit(37) = ”Maintenance required”
Unit_Diag_Bit(38) = ”Characteristics invalid”
Unit_Diag_Bit(39) = ”Ident_Number violation”
;–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––