Moniteur 50 Series SMART Positioners - Manual (Page 43)

Preparing for Operation
3-5
Positioner SIPART PS2/SIPART PS2 PA
C79000-G7476-C150–01
8. Fit the mounting bracket (1) with two hexagon head screws (9),
spring washer (10) and U-washer (11) on the rear of the positioner.
9. Selection of the row of holes depends on the width of the actuator
yoke. The roll (5) should engage in the pick-up bracket (2) as close
to the spindle as possible, but must not touch the clamping assem-
bly.
10.Hold the positioner with the mounting bracket on the actuator such
that the pin (4) is guided within the pick-up bracket (2).
11. Tighten the pick-up bracket.
12.Position the mounting parts according to the type of actuator.
– Actuator with ledge: hexagon head screw (8), U-washer (11) and
spring washer (10).
– Actuator with plane surface: four hexagon head screws (8),
U-washer (11) and spring washer (10).
– Actuator with columns: two U-bolts (7), four hexagon nuts (21)
with U-washer (11) and spring washer (10).
13.Secure positioner onto the yoke using the previously positioned
mounting parts.
☞
Note
Adjust the height of the positioner such that the horizontal lever
position is reached as close as possible to the center of the stroke.
You can use the stroke scale of the actuator for orientation. It must
always be guaranteed that the horizontal lever position is passed
through within the stroke range.