Juniper Systems JS600 - Manual (Page 79)

PolyTools Program Page 7-19
Select the Set up Parameters submenu option. The following submenu screen appears:
The default values for the communication parameters are shown. To view the options for each
parameter (shown in the graphic above), highlight the displayed value and press . To
change a parameter, scroll up and down the list, highlight the desired parameter, and press
. For example, if you wish to modify the baud rate to 4800 (to slow the transfer of
information), highlight 9600 with the highlight bar, press , use the down arrow key to
highlight 4800, and press . To save the value you selected, you must press
before returning to the Transfer Files submenu.
Choose Mating Call
Another communication parameter that must correspond with the FieldBook is the mating
call. Select the Choose Mating Call submenu option. Key in the correct mating call
character and press .
Viewing Information as it is Transferred
If you wish, you can view information as it is being transferred on the computer display. Select
the View Transfer submenu and highlight Yes. Keep in mind that the transfer time increases if
you choose to do this. If you do not wish to view the information while it is transmitting, select
No.
Setting up the FieldBook
On the FieldBook, the communication parameters are set up in Mode 5-2, Set Communication
Protocol. Refer to Section 3, Operating System, Operating Modes, Mode 5: Set, and Section 5,
Sending and Receiving Information for details.
Test Terminal Mode
If the baud rate, parity, data bits, stop bits, communication port, and mating call parameters
set up on the computer and FieldBook match, you are able to send information between them
in Test Terminal Mode.
Baud Data Stop Comm
Rate Parity Bits Bits Port
9600 NONE 8 1 COM1
9600 NONE 8 1 COM1
4800 ODD 7 2 COM2
2400
1200
600
300
F1: help F2: modify F10: exit ESC: abort