Juniper Systems JS600 - Manual (Page 36)

Page 3-20 Operating System
Keyboard Entry Next Message Shown Action
Parity STOP BITS 1/2 Enter the desired number of stop bits. Valid
or just L 1!1 entries are 1 (default) and 2.
to accept defaults
Stop Bits DUPLEX Enter the duplex setting for transmissions.
or just L 1!H Valid entries are:
to H = Half duplex (default): in terminal mode,
accept default the character is displayed on the screen
before being transmitted
F = Full duplex: in terminal mode, the
character is displayed on the screen
only after being echoed back by the
computer
Duplex XMITS PMTS Y/N If you wish to transmit the column prompts
or just L 1!N at the top of each page, enter a Y for yes. The
to accept default default is N, no column prompts.
Y or LINE REQ A line request character can be designated as
just to L 1!A any ASCII character. The FieldBook interprets
accept default a line request character received from either
the keyboard or the I/O port as a prompt to
transmit one line. The default is A.
Line request REPEAT REQ A repeat request character can be designated
character L 1!B as any ASCII character. The FieldBook
or just inteprets a repeat request character received
to from either the keyboard or the I/O port as a
accept default prompt to transmit the last line transmitted
again. The default is B.
Repeat request CONTINUOUS REQ A continuous request character can be
character L 1!C designated as any ASCII character. The
or just FieldBook interprets a continuous request
to character received from either the keyboard
accept default or the I/O port as a prompt to transmit the
remainer of the data without pausing between
lines. The default is C.