Juniper Systems JS600 - Manual (Page 69)

PolyTools Program Page 7-9
- Insert: Insert mode is active. The character you type from the keyboard is inserted at the
current cursor position. Insert mode can be toggled on and off by using the key or
by typing . If the word “Insert” is not present on the status line, the editor is in
Overwrite mode. As a character is typed from the keyboard, it overwrites the
information
present at the current cursor position.
- Indent: Indicates that the auto-indentation is on. The Indent mode can be toggled on and
off by pressing .
-
Editing Commands
The PolyTools editing commands are issued by pressing the “Control” (Ctrl) key on the
keyboard in conjunction with any other key from A to Z. The editing commands are described
on the following pages. (A quick reference to the editing commands is included at the end of
Section 7 for your convenience.)
Cursor Movement Commands
or :
Moves the cursor one character position to the left. It is a non-destructive backspace. When the
cursor reaches the left edge of the display, it stops.
or :
Moves the cursor one character position to the right. It is a non-destructive forward space.
When the cursor reaches the right edge of the video display monitor, the text starts scrolling
until the cursor reaches the last column in the line (column 250).
or :
Moves the cursor to the beginning of the word to the right of where the cursor was at the time
the command was initiated.
or :
Moves the cursor up one line. The screen scrolls down one line if the cursor is at the top line of
the screen.
or :
Moves the cursor down one line from its current position. The screen scrolls up one line if the
cursor is at the bottom line of the screen.
:
Scrolls up towards the beginning of the file, one line at a time. The cursor remains in position
until the top of the screen is reached.
:
Scrolls down towards the end of the file, one line at a time. The cursor remains in position
until the bottom of the screen is reached.