Juniper Systems JS600 - Manual (Page 76)

Page 7-16 PolyTools Program
To execute PolyTran and begin translating the program, press . The following screen
appears:
It may take a few minutes for PolyTran to execute, depending on the length of the
program. While PolyTran is executing, messages appear in the message screen. The
numbers of the lines being translated is also displayed.
Upon completion, the lower screen shows the final line number. If no errors were detected, the
following message is displayed on the screen:
Error Codes and Warning Messages
If errors are found in your program, PolyTran displays the line numbers, the error
numbers, and a description of the errors. A list of error codes and warnings and their corre-
sponding messages is included at the end of Section 7. Warnings about potential problems are
also displayed in the message screen. For example, if you created a program and left off the
mnemonic END, the message screen would appear as follows:
The line number may be off by one line because the error may not be detected until PolyTran
has moved to the next line.
PolyTran
File: Filename Line:
total 0 error(s) and 0 warning(s)
any key to continue...
ERROR 1033:Line 51 in File Filename
—>no END statement
total 1 error(s) and 0 warning(s)
any key to continue...