Juniper Systems JS600 - Manual (Page 102)

Page A-6 Appendix
System Reset and @@SYS Inhibit Connector
The RESET/@@SYS Inhibit Connector included with your FieldBook consists of two 25-pin
subminiature D female connectors back-to-back in one connector package. One side is
labeled RESET and the other is labeled @@SYS.
▲ ▲ ▲ ▲ ▲ RESET Connector
The RESET end of the connector resets the FieldBook,
erasing all data and programs stored in memory.
To reset the FieldBook, plug the RESET end of the
connector into the serial port of the FieldBook, then turn
the FieldBook on. EVERYTHING IS ERASED!
Wiring Schematic
Pin Pin
14 Digital Out 1 Digital In 1 1
15 Digital Out 2 Digital In 2 8
17 Digital Out 3 Digital In 3 11
▲ ▲ ▲ ▲ ▲ @@SYS Program File Inhibit Connector
The @@SYS end of the connector inhibits the automatic
execution of @@SYS programs on the FieldBook.
Plug the @@SYS end of the connector into the FieldBook's
serial port. The MODE? prompt is shown when the
FieldBook is turned on or when is pressed instead
of the @@SYS program.
Wiring Schematic
Pin Pin
14 Digital Out 1 Digital In 2 8
15 Digital Out 2 Digital In 3 11
17 Digital Out 3 Digital In 4 13
For more information about the RESET/@@SYS Inhibit Connector, refer to Section 6,
Programming the FieldBook, System Reset and @@SYS Inhibit Connector.
PR-713
RESET