Brother MFC7650MC - Manual (Page 98)

iii
2. Wait for two seconds.
3. Press 1.
4. Press 6 .
5. Press 6 .
E . F A X
2 . P R I N T E R
-
1 . F A X
6 . T E L O P T I O N S
6 . D I S T I N C T I V E
c
D I S T I N C T I V E i O F F
S E L E C T e ^ & S E T
:)
6. Press ^ (left arrow) or (right arrow)
to find the SET mode.
7. Press Set.
8. Press Stop.
NOTE: The display should say D/R SET
MODE. Also, the answer mode
lights will flash. You must now
wait for someone to call the
distinctive ringing fax number.
TROUBLESHOOTING TIP---------------
D I S T I N C T I V E i S E T
6 . D I S T I N C T I V E
D / R S E T M O D E
O N L I N E
If your MFC display says D/R SET MODE and you are not in the process of
setting up a distinctive ringing number, press the Stop key to exit this function.
The settings will remain unchanged.
9. When the phone rings, listen carefully to
check that the ringing pattern is the one
you want to register. If it is, wait until the
display says PICK UP TO SET. Then pick
up the fax handset.
10. Press Start Lu set. Check lliaL Lhe display
says REGISTERED.
(If the other number was called, press
Stop to cancel.)
11. Press Start again to receive the incoming
fax, or if the call is a voice call, talk into
the handset.
P I C K U P T O S E T
O N L I N E
c
S T A R T T O S E T
O N L I N E
S T O P T O C A N C E L
O N L I N E
K E O i i 1 E K E D
-------
O N L I N E
V ............................... ____ j
T E L E P H O N E / F A X
O N L I N E
86