Brother MFC7650MC - Manual (Page 135)

v^l—l V I l_i\ I V I ' ^ L V L . 01-1 I II > I V 7 0
Remote Control Commands
You can program and control your MFC with remote control commands.
rtemote control commands Detail Operation
91 Playing voice messages After one long beep, the MFC plays ICM, Memo and Voice Alarm.
I (Skip back) Press 1 while listening to an ICM, Memo or Voice Alarm message to play
it again. If you press 1 before a message, you will hear the previous
message.
(Skip next) While playing ICM, Memo and Voice Alarm, you can skip to next
message.
9 STOP Playing Stop playing ICM, Memo and Voice Alarm.
92 Record Memo After one long beep, you can record a memo. You can stop recording by
pressing 9.
93 Erase all ICM & Memo If you hear one long beep, the erase is accepted. If you hear three short
beeps, you cannot erase because all voice messages have not been played,
or there ifi no voice message to erase.
*Tliis code erases all recorded messages, not one by one.
94 Play and Record OGM
in memory
1 Play 1 MSGCTROGM
2 F/T OGM
The MFC plays the selected OGM. You can stop playing OGMs by
pressing 9.
After one long beep, you can record the selected OGM. You will hear the
OGM message played once. You can stop recording the message by
pressing 9.
2 Record 1 MSGCTROGM
2 FfT OGM
95 Clinnging Fax Forwarding
/Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWn NO
If ^011 litJar one lung beep, the Liinjuge is iteeepted. Ifyuu hear thiee sliurL
beeps, you cannot change it because the conditions (ex. registering
paging number) have not been completed. You can register your fax
forwarding number by using 4. FAX FWD NO (see page 124). Once you
have regis Lered the number, the
MFC will automatically change to "FAS
FWD:ON” mode. Then retrieve a Memory Status List by entering 961
(see page 124). After you make sure that the Fax Forwarding number you
registered is correct in the List, enter the confirmation command 955.
Now the
MFC wiU start Fax Forwarding.
5 FWD NO. CONFIRM
96 Retrieve FAX
1 Memory Status List
2 00 Retrieve all FAX
You must call from a remote fax machine to receive the Memory Status
List or stored fax messages. (See page 124.)
2 00
Retrieve by MSG
number
3 Erase FAX in the
memory
If you hear one long beep, yon can erase the fax message ftom the
memory.
97 Check the receiving status
1 PAX
You can check whether your MFC has received any FAX or VOICE
messages. If yes, you wiU hear one long beep. If no, you will hear three
short beeps.
2 VOICE
98 Change Answer Mode
1 MSG CTR
"2 F/T ~
3 FAX
If you hear one long beep, you can change the answer mode. If you hear
three short beeps, you cannot change it. (Example: There is no MSG CTR
OGM when you want to change to MSG CTR mode.)
90 Exit
12S