Brother MFC7650MC - Manual (Page 203)

Troubleshooting Tips
If you think there is a problem with your MFC, make a copy first. If the copy looks
good, the problem is probably not your MFC. Check the chart below and follow the
troubleshooting tips.
Setting Up the MFC
The MFC does not print.
Suggestions
Check the following;
• The MFC is turned on.
• The toner cartridge and drum unit are installed properly.
• The interface cable is securely connected between the MFC
and computer.
• Check to see if the LCD is showing an error message. (See
pages 182-184.)
1.................... .... ..........
Windows® Setup Prlntlr
1_______________________________________________________ 1
ig Dirricultles
Difficulty Suggestions
i cannot print from my
application software.
i
■
• Make sure the Windows® printer driver is installed and you
selected it in your application software.
• If you use the optional serial interface, make sure the serial
slide switch of the serial interface is in the correct position and
the DIP switches interface settings are correctly set up.
Sometimes I get an
error message, PRINT
OVERRUN when
printing certain
documents from
Windows®.
• If you are using the suppHed Windows® driver, turn the error
recovery operation on in the Setup dialog box and try again.
• Reduce the print resolution or reduce the complexity of your
document and try again.
• Expand the printer memory by installing one of the optional
memory hoard.s
i_______ ^_______________________________________________
191