Brother MFC7650MC - Manual (Page 90)

8. Enter new remote code to activate. (Factory
setting is ^51.) Then press Set.
9. Enter new remote code to deactivate.
(Factory setting is #51.)
1 0 . Press Set.
11. Press Stop to exit.
A C T . C 0 D E : * 5 1
D E A C T . C 0 D E : f 5 1
5 ; R E M 0 T E C O D E
C) CONNECTING AN EXTERNAL TELEPHONE ANSWERING
device (TAD)
How to Use an External TAD with the MFC
When you have an external Telephone Answering Device on the fax phone line, the
TAD will answer all the incoming calls. Your Brother MFC will listen in on the line
for fax CNG tones. If it hears them, it will take over the call and receive the fax
message. If it does not hear fax tones, it will let the TAD continue playing the outgoing
message so the caller can leave a voice message.
The TAD must answer within 4 rings. The MFC cannot hear the CNG calling tones
until the TAD answers the call. When the Ring Delay is set for 4 rings, only 8-10
seconds of CNG calling tones are left for the “handshake”. So you must strictly follow
the instructions for recording the OGM.
You must erase the incoming messages frequently on your TAD. When the TAD’s
memory is full it will not answer any incoming calls (fax or voice).
Put your MFC in Message Center mode and set Message Storage to VOICE: EXT
mode. (See page 99.)
78