Setting the print density, Keys to press, The display will show – Brother MFC7650MC User Manual
Page 83: Rvaco, I htk
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

. VII
I
rvAco
U
I Htk
CALLS
FOR YOUR INFORMATION
Reception into Memory (Out of Paper Reception)
I f t h e multi-pTorpose sheet feeder is empty, the LCD will display the
message CHECK PAPER. Add more paper.
Your MFC automatically will store incoming faxes in its memory if it runs
out of paper. The contents of the memory will be printed automatically
when you replace the paper. The memory for out of paper reception will be
saved for up to 2 hours after power has been cut off.
Setting the Print Density
You can set print conditions with the following steps. Press (left arrow) to make
the print lighter and ► (right arrow) to make the print darker. If the print is still too
light or too dark, you can adjust it further by turning the Print Density Dial located
in the right comer under the top cover. (Remove the dram unit to find the dial. See
page 186 for more information.)
KEYS TO PRESS
1 Press Function.
2. Wait for two seconds.
3. Press 1.
4. Press 5.
5. Press 9.
The display will alternate messages.
6. Use
(left arrow) or
(right arrow) to
change the settings.
7. Press Set.
8. Press Stop to exit.
THE DISPLAY WILL SHOW:
0 9 / 1 2 / 1 9 9 8
1 5 : 2 5
O N L I N E
E N T E R N O . & S E T
Q J . F A X
2 . P R I N T E R
1 . F A X
5 . U S E R O P T I O N S
9 . P R I N T D E N S I T Y
C
!□□□□□□□+
S E L E C T ^ & S E T
3
9 . P R I N T D E N S I T Y
71