FaxBack NET SatisFAXtion 9.0 - Fax Server Manual - Manual (Page 189)

FlowSpec. Default: 13875.
t38_qos_token_bucket_size [dword 0–65535]: TokenBucketSize of sending T.38 RSVP
FlowSpec. Default: 680.
t38_qos_latency [string]: Latency of sending T.38 RSVP FlowSpec.
Default: QOS_NOT_SPECIFIED.
t38_qos_delay_variation [string]: DelayVariation of sending T.38 RSVP FlowSpec.
Default: QOS_NOT_SPECIFIED.
t38_qos_service_type [string]: ServiceType of sending T.38 RSVP FlowSpec.
Default: SERVICETYPE_GUARANTEED.
t38_qos_max_sdu_size [dword 0–65535]: MaxSduSize of sending T.38 RSVP FlowSpec.
Default: 340.
t38_qos_minimum_policed_size [dword 0–65535]: MinimumPolicedSize of sending T.38
RSVP FlowSpec. Default: 340.
IP_FAX Device
allowed_receive_baud_rates [string]: This setting restricts a modem to use only
certain baud rates. Use this to block a modem from using a rate or rates that it
supports, but are unreliable in your environment or are undesirable for some other
reason. On transmitting, use this as a mask; the modem will use only those rates you
list. On receiving, set the fastest and slowest rates; the modem will allow those and any
in between.
Format: Comma separated list of 14400, 12000, 9600, 7200, 4800 and 2400.
Default: 14400,12000,9600,7200,4800,2400.
allowed_send_baud_rates [string]: This setting restricts a modem to use only
certain baud rates. Use this to block a modem from using a rate or rates that it
supports, but are unreliable in your environment or are undesirable for some other
reason. On transmitting, use this as a mask; the modem will use only those rates you
list. On receiving, set the fastest and slowest rates; the modem will allow those and any
in between.
Format: Comma separated list of 14400, 12000, 9600, 7200, 4800 and 2400.
Default: 14400,12000,9600,7200,4800,2400.
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or “answering”
states for a carrier from the remote device before hanging up. Default: 45.
csid [string(20)]: The CSI for receive and the TSI for send.
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state before
hanging up. Default: 45.
fax_device_name [string]: Optional device name that will override the key name that
is used for the fax device name. Typically this is never used. Format: Up to 32
characters.
phone_number [string]: Specifies a value that the IP fax driver sets in the From:
header of SIP messages that it creates, identifying the IP fax port. A VoIP router can, if
so configured, pass along this value as the caller ID (ANI) for the outbound fax call.
Proprietary FaxBack, Inc. 2014 189