FaxBack NET SatisFAXtion 9.0 - Fax Server Manual - Manual (Page 175)

ser_device_name [string]: Win32 name for the serial port in the format of COMXXX where
XXX can be 001–999. This does not need to be specified if the tapi_modem_name is specified.
Format: Up to 6 characters.
init_string [string]: This is the basic modem initialization string. It should reset the modem
and init the required flow control. Format: Up to 80 characters.
Default: &F&C1&D2V1E0S0=0S7=90^^.
All modem commands start with AT, so this string does not need AT. The symbols
in the string mean the following:
^ 2­second pause
\ Carriage return. There is a wait of init_string_timeout_msecs after carriage return to wait
an OK to be returned.
\\ Specifies a single \
^^\ this is interpreted as \^^
init_string_timeout_msecs [dword 0–65535]: How long to wait for response after CR in the
init_string if there are no 2­second pauses before or after the CR. Default: 5000.
close_string [string]: Determines what commands should be sent to a fax modem to restore it
to its normal state of operation after the application has finished using it. See init_string
description for string format explanation. Default: Z^^.
io_buffer_size [dword 0–65535]: This is the size of the image buffer. The necessary buffer
size depends on host CPU speed and load as well as connect speed. This buffer directly adds to
driver page locked memory use so should be as small as possible. However, too small a buffer
will cause faxes to fail. Default: 20480.
show_console_scroll_back_buffer_size [dword 0–4294967295]: When the debug output
is CONSOLE, this is how big of a buffer to be used for scrollback. Default: 282144.
show_ring0_buffer_size [dword 0–4294967295 ]: How big of buffer for the page locked
debug buffer that ring0 code writes to and ring3 code extracts from (on a thread) to the
debugging output. This should be larger for when using serial capture mode since so much more
data is written for debug. It should probably be only about 1K for when using T.30 debug since
the frequency and amount of T.30 debug is small enough that the ring3 code can easily keep up
writing to the show output. Default: 65536.
debug_show_file_path [string(256)]: Partial path or complete path and file name of where to
create debug file. If the debug_show_output is set for CONSOLE and the debug_show_file_path
is specified in the registry, then you can get both CONSOLE and FILE debug output
simultaneously. This is a device specific setting, but you can set the default for all devices by
specifying this under the global icanfax section.
debug_show_output [string]: Debug output that displays various run time behavior of
ICANFax. When specifying the FAX_DEVICE, the ICANFax debug output will be mixed in with
the fax drivers debug output. This is a device specific setting, but you can set the default for all
devices by specifying this under the global section. Format: One of the following values.
Default: NONE.
NONE
CONSOLE
FILE
FAX_DEVICE
SERIAL_CAPTURE
TCP
csid [string(20)]: The CSI for receive and the TSI for send.
allowed_receive_image_types [string]: These settings control the image types that the
device can send and receive via the T.30 protocol over the telephone network. To receive or
Proprietary FaxBack, Inc. 2014 175