FaxBack NET SatisFAXtion 9.0 - Fax Server Manual - Manual (Page 185)

audio_qos_latency [string]: Latency of sending RTP RSVP FlowSpec.
Default: QOS_NOT_SPECIFIED.
audio_qos_delay_variation [string]: DelayVariation of sending RTP RSVP FlowSpec. Default:
QOS_NOT_SPECIFIED.
audio_qos_service_type [string]: ServiceType of sending RTP RSVP FlowSpec.
Default: SERVICETYPE_GUARANTEED.
audio_qos_max_sdu_size [dword 0–65535]: MaxSduSize of sending RTP RSVP FlowSpec.
Default: 340.
audio_qos_minimum_policed_size [dword 0–65535]: MinimumPolicedSize of sending RTP
RSVP FlowSpec. Default: 340.
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or “answering” states
for a carrier from the remote device before hanging up. Default: 45.
csid [string(20)]: The CSI for receive and the TSI for send.
debug_show_file_path [string(256)]: Partial path or complete path and file name of where to
create debug file. If the debug_show_output is set for CONSOLE and the debug_show_file_path
is specified in the registry, then you can get both CONSOLE and FILE debug output
simultaneously. This is a device specific setting, but you can set the default for all devices by
specifying this under the global ICANFax section.
debug_show_mode [string]: Specifies the types of debug information to output.
Format: Comma separated list of one or more of the following.
Default: T30,SIP,API,T38,T38_DATA,T38_IMAGE.
T30 Contents of all sent or received T.30 messages (fax protocol signals like CSI, DIS,
TSI, DCS, etc.).
SIP The contents of each sent or received SIP packet.
API Internal API state.
T38 The basic contents of each sent or received T.38 packet. Required for all the
remaining T38 debug types except T38_PKT.
T38_ERROR_RECOVERY List the contents of the secondary (redundant) payload in each
T.38 packet. This option generates a lot of data.
T38_DATA Dump the decoded bytes of any low­speed T.38 (control) packets both
primary and secondary (redundant) payloads. This option generates a lot of data.
T38_IMAGE A brief summary of any high­speed T.38 (image) packets both primary and
secondary payloads.
T38_IMAGE_DATA Dump the decoded bytes of any high­speed T.38 (image) packets
both primary and secondary (redundant) payloads. This option generates a lot of data.
T38_PKT Dump the raw bytes of each T.38 packet received. This option generates an
extremely large amount of data and is only used to diagnose possible T.38/ASN.1
parsing problems.
Proprietary FaxBack, Inc. 2014 185