FaxBack NET SatisFAXtion 9.0 - Fax Server Manual - Manual (Page 183)

Default: 14400,12000,9600,7200,4800,2400.
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or “answering” states
for a carrier from the remote device before hanging up. Default: 45.
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state before hanging up.
Default: 45.
tapi_modem_name [string(128)]: When specified, the driver will utilize TAPI so as to not
monopolize the usage of the serial port. This is the name of the modem defined in the control
panel modem applet.
tapi_modem_name_saved [string(128)]: Copy of tapi_modem_name.
fax_device_name [string(32)]: Optional device name that will override the key name that is
used for the fax device name. Typically this is never used.
csid [string(20)]: The CSI for receive and the TSI for send.
4.2.1.4 Convert
header_font [string]: Font used for fax header text conversion.
Default: {ProgramPath}\Fonts\header.fnt.
compressed_font [string]: Font used for compressed text document conversion.
Default: {ProgramPath}\Fonts\compress.fnt.
normal_font [string]: Font used for plain text document conversion.
Default: {ProgramPath}\Fonts\normal.fnt.
4.2.1.5 IP_FAX Global
allowed_receive_baud_rates [string]: This setting restricts a modem to use only certain
baud rates. Use this to block a modem from using a rate or rates that it supports, but are
unreliable in your environment or are undesirable for some other reason. On transmitting, use
this as a mask; the modem will use only those rates you list. On receiving, set the fastest and
slowest rates; the modem will allow those and any in between.
Format: Comma separated list of 14400, 12000, 9600, 7200, 4800 and 2400.
Default: 14400,12000,9600,7200,4800,2400.
allowed_send_baud_rates [string]: This setting restricts a modem to use only certain baud
rates. Use this to block a modem from using a rate or rates that it supports, but are unreliable
in your environment or are undesirable for some other reason. On transmitting, use this as a
mask; the modem will use only those rates you list. On receiving, set the fastest and slowest
rates; the modem will allow those and any in between.
Format: Comma separated list of 14400, 12000, 9600, 7200, 4800 and 2400.
Default: 14400,12000,9600,7200,4800,2400.
allowed_receive_image_types [string]: These settings control the image types that the
device can send and receive via the T.30 protocol over the telephone network. To receive or
send some image types, the corresponding allowed_receive/send_transfer_type setting must
include ECM. Format: Comma separated list of the following. Default: 1D,2D,T6,JBIG.
1D
2D
T6
Proprietary FaxBack, Inc. 2014 183