Msi-9850 – Rice Lake MSI-9850 CellScale RF Digital Indicator - Operator Manual User Manual
Page 40

Page 40 MSI-9850 RF Remote Indicator • User Guide
MSI-9850
HANDHELD RF REMOTE INDICATOR for
C
ELL
S
CALE
®
Enter ID String 1
...........Allows direct entry of ID String 1 which can be used for any text entries.
Enter ID String 2
...........Allows direct entry of ID String 2 which can be used for any text entries.
Moved “Start/Stop Comm 1” and “Start/Stop Comm 2” to the SEND/PRINT Group. Moved all the Print choices to the SEND/PRINT group.
5 – Bar Code Group
Get BarCode 1
...............Opens Bar Code 1’s input entry buffer to receive data from Comm Port 2.
Get BarCode 2
...............Opens Bar Code 2’s input entry buffer to receive data from Comm Port 2.
Get BarCode 3
...............Opens Bar Code 3’s input entry buffer to receive data from Comm Port 2.
Get BarCode 4
...............Opens Bar Code 4’s input entry buffer to receive data from Comm Port 2.
Get All BarCodes
..........Programs key to open all enabled bar code buffers in order. All bar codes must be
assigned a length in the autostart bar code menu. Can include ID print strings.
Clear ID & Bar Strings
Clears all ID and Bar Code Strings. ???? Clear Strings Move to Bar Code ????
6 – Text Messaging Group
Send Message to 1
.......Sends Message String to CellScale Comm Port 1.
Send Message to All
....Sends Message String to CellScale Comm Port 1 and to CellScale RF Host 3, 4, and
5.
Send Message to 3
.......Sends Message String to CellScale RF Host 3.
Send Message to 4
.......Sends Message String to CellScale RF Host 4.
Send Message to 5
.......Sends Message String to CellScale RF Host 5.
Reply Last Message
....Send Reply to source of last received message.
7 – Data Logging Group
Store to Memory 1
........Outputs Comm 1 print string to data logging memory 1.
Store to Memory 2
........Outputs Comm 1 print string to data logging memory 2.
Store to Memory
...........Outputs Comm 1 print string to data logging memory 1 or 2 depending on the setting
in the Data Logging Control menu.
Aux to Memory 1
..........Outputs the Auxiliary string to data logging memory 1.
Aux to Memory 2
..........Outputs the Auxiliary string to data logging memory 2.
Aux to Memory
..............Outputs the Auxiliary string to data logging memory 1 or 2 depending on the setting
in the Data Logging Control menu.
Data Logging Cntl
........Brings up the Data Logging control menu for uploading and erasing data.
8 – Set Point Group
Enable Set Points
.........Enables the Set Points by F-Key push. Used for Start.
Disable Set Points
........Disables the Set Points by F-Key push. Used for Stop.
Enable/Disable SPs
......Push On/Push Off control of Set Points
Set Pt Momentary
.........Enables remote Set Point Relay while being pushed. Sub-menu specifies which Set
Point is forced on.
Set Pt On
.........................Turns remote Set Point Relay on. Specify Set Point in Sub-menu.
Set Pt Off
........................Turns remote Set Pont Relay off. Specify Set Point in Sub-menu.
Set Pt Push On/Off
.......Toggles Set Point Relay on/off. Specify Set Point in Sub-menu.
Clear Latched SP’s
.......Clears any latched Set Point. However, if the Set Point is still triggered this key will
not turn it off.
Display Set Points
........Observe current status of Set Points. Configure set points. ???? Move to tests????
Go to Index