Mercedes-Benz SLS-Class 2013 COMAND Manual - Manual (Page 97)

Displaying real-time traffic reports
Calling up a list
X To switch to navigation mode: press the
Ø function button.
X To show the menu: press W the COMAND
controller.
X Select Traffic Traffic by turning cVd the
COMAND controller and press W to
confirm.
If the dialog field shows the "No Traffic
Messages" message, this means that:
R no traffic reports have been received yet.
R no traffic reports are available.
X To cancel the search: select Cancel Cancel and
press W to confirm.
X To close the report window: select OK OK
and press W to confirm.
If traffic reports exist, a list is shown.
The content of the list varies depending on
whether route guidance is active or not.
List when route guidance is not active
The list shows all the roads, areas or regions
for which reports are available.
A traffic report may refer to an area or a
region, e.g. if visibility is impaired due to fog.
X Calling up a list(
Y
page 95)
X
To read a traffic report: select a road,
area or region by turning cVd the
COMAND controller and press W to
confirm.
List when route guidance is active
The first list shows the roads, areas and
regions that lie along the route and for which
traffic reports are available.
X Call up a list (
Y
page 95).
X To show all reports: select Display Display All All
Messages Messages by turning cVd the COMAND
controller and press W to confirm.
You see a list of all roads, areas and regions
for which traffic reports are available, even
if the reports do not affect your route.
X To show a traffic report: select a road,
area or region and press W to confirm.
X
To close the list: slide XVY the COMAND
controller.
Traffic reports
95
Navi
ga
tio
n
Z